You can also use user defined, and change the vinyl width. It is in the software, and determines the vinyl width. Yes, I can pick a piece out of a design and cut it. ![]() And it also has it's own contour cutting program, could be used on another cutter as such. Can you isolate two spots (or more) on a design and just cut those two leaving a user determined (say 1/4") overlap to patch it up and will the program nest those so as to utilize the vinyl as efficiently as possible?ĭoes flexi read the vinyl width from the cutter? Or do you have to tell it how wide it is?Ĭan you insert weeding lines and a weed boarder?ĭoes Flexistarter have a cut by color option? You have a large detailed design and during the install you make two mistakes and need to replace one little piece over here and another little larger spot over there where the wind blew and the vinyl stuck to itself and is ruined. ![]() Ok let me give you a few real world scenarios to see if it is comparable to SignCut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |